← All energy systems

Energy technology profile

Charged-particle direct conversion

Direct conversion aims to turn the organized motion of charged reaction products into electricity without a heat engine. It is especially relevant to advanced fusion fuels.

  • fusion
  • electrostatic conversion
  • power electronics

Technical deep dive

How it works

Electrostatic concepts slow positively charged fusion products across a high-voltage potential, transferring kinetic energy into a circuit. Inductive concepts use changing particle currents or expanding magnetized plasma to induce current in surrounding coils. Real devices must separate useful particles from the plasma, tolerate extreme voltages and radiation, and maintain efficiency across a broad energy distribution.

Electrostatic conversion

A positively charged reaction product climbing an electrostatic potential loses kinetic energy. In a multistage converter, electrodes at successively higher potential sort and decelerate particles; current delivered to those electrodes can feed a power-conditioning circuit. The ideal stopping voltage is tied to particle energy per unit charge, so a monoenergetic beam is much easier to convert than a broad fusion-product spectrum.

Real grids and collectors intercept particles, emit secondaries, and experience sputtering and heating. Space charge changes the intended field, while escaping plasma electrons can neutralize the beam or short the potential. Magnetic expansion and species separation are therefore often needed before electrostatic collection.

Inductive and travelling-wave routes

An expanding magnetized plasma or pulsed charged-particle current changes magnetic flux through external windings and induces an electrical current. Travelling-wave concepts phase a sequence of electrodes or coils with particle bunches, allowing distributed deceleration without placing a fragile grid directly in the highest flux.

These routes trade extreme static voltage for timing, impedance matching, switching, and plasma-control problems. Energy spread, pitch angle, pulse duration, and coupling to the magnetic field determine how much organized kinetic energy reaches the circuit instead of becoming heat.

System boundary

Direct conversion can only collect the fraction of source power carried by accessible charged products. Neutrons, gamma rays, radiation striking structures, and uncollected exhaust still require shielding and usually a thermal-recovery loop. The converter also needs insulation, vacuum, magnets, and bidirectional high-voltage power electronics.

A useful plant metric is net DC or AC electricity divided by total reaction power after subtracting recirculating power. Component conversion efficiency measured with a prepared beam should not be applied unchanged to a hot, divergent, mixed-species fusion exhaust.

Reason to use it

What could make it valuable

Direct conversion may avoid turbine losses, deliver electrical output quickly, and reduce some of the cooling equipment required by a thermal power cycle.

Unresolved engineering

What still blocks it

The converter must collect particles with a wide spread of energies while controlling plasma escape, radiation, arcing, very high voltage, and electrode or coil loading.

Avoiding an intermediate thermal cycle could raise efficiency and simplify heat rejection if an appropriate charged-particle source becomes practical.

Monthly evidence layer

Research watch

Named programs, dated developments, and primary or official sources. Company claims are identified separately from independent or peer-reviewed evidence.

Last reviewed 6 September 2026

Research groups & programs

Current developments

  1. 2025

    Modern theory reconnects converter design to reactor power balance

    Recent work models direct conversion together with plasma exhaust properties rather than treating collection as an isolated ideal stage.

  2. June 2026

    Company demonstration reported

    Realta announced a direct-energy-conversion experiment. It is tracked as a company result, not yet as an independently replicated plant benchmark.

Papers & official resources